Lamp-to-be

Sphere cut cleanly at 1/3 or so, hole punched through, black slip over (looks almost like carbon fiber.) cylinder w/top and bottom cut cleanly at 1/3, top rounded to sphere, divot to hold sphere w/hole punched through center. Black slip again. Once fired, acrylic or plate glass will go in the cuts, with lights run inside and glowing out through the transparent material.

Would have been nice to make the sphere fully solid, and use inductive power to run a led inside it, but I wasn’t sure what distance inductance could work over. Next time.

20131218-144514.jpg

A few more glazed

I can already tell that the little black cup is going to be one of my all-time favorites…

20131218-123103.jpg